Control I/O pins with a webhook

This is an Arduino IDE sketch for a "smart" controller that can activate pins based on the state of some webpage. The motivating use cases are:

• Controlling a PC power switch remotely, using a transistor wired to the power switch pins
• Lighting specific LEDs to create a remotely controlled 'traffic light'.

This sketch currently targets only the ESP8266, and will probably not work with other microcontrollers. Support for other boards may come if I run out of ESP8266's.

Configuration

First:

cp config.h.example config.h

Then edit config.h and fill in the correct values for your environment.

PIN_MAP in config.h is an array of pins that we want to control. Each item in the array is itself an array, with the following format:

[output_pin, control_mode]

The index of the item in the top-level array is its 'index' value in the webhook. (see webhook data, below)

output_pin is the pin to control.

control_mode is either 0 or 1. 0 is for momentary mode; that is, when the state is active the pin will only be high for a short time. 1 is for latched mode; the pin will stay high until the state changes.

Building

TODO

Webhook data

The webhook should always return a page in the following format:

index_0 state_0
index_1 state_1
...

Where index and state are both integers. If you are expecting momentary input, you should return the state to '0' after the page is served / the webhook is consumed.